Modeling Heat and Power Generation for Green Buildings based on Solid Oxide Fuel Cells and Renewable Fuels (Biogas) | ||
| Renewable Energy Research and Applications | ||
| مقاله 6، دوره 1، شماره 1، فروردین 2020، صفحه 55-63 اصل مقاله (1.23 M) | ||
| نوع مقاله: Original Article | ||
| شناسه دیجیتال (DOI): 10.22044/rera.2020.8985.1010 | ||
| نویسندگان | ||
| M. Beigzadeh؛ F. Pourfayaz* ؛ S.M. Pourkiaei | ||
| Department of Renewable Energies, Faculty of New Sciences and Technologies, University of Tehran, Tehran, Iran | ||
| چکیده | ||
| The use of green buildings is increasing these days and many activities in order to improve the efficiency of this type of constructions have been done by the advancement of technology. Fuel cells are one of equipment which have been used to generate power and heat for residential buildings in recent years. For this purpose, a building in a cold region has been studied. In this study, the fuel of the fuel cell is provided from renewable fuel reforming, which is fermentation of waste and wastewater. First, a SOFC modeling has been carried out which is fed by biogas from a building waste. The modeling results of renewable-fuel fuel cell of this building have showed that 72% of electricity and 13% of the required heating could be provided using its wastes. All in all, by using biogas which has been produced from building waste, most required power and a part of required hot water could be provided and the environmental pollution is reduced by utilizing waste and trash. This will utilize all waste of the building for biofuels production and also provides major of the electricity and heating demand of the building. | ||
| کلیدواژهها | ||
| Green buildings؛ fuel cells؛ renewable fuels؛ environmental pollution؛ Biogas | ||
| مراجع | ||
|
[1] Ahmadi, MH, et al. (2019), Thermodynamic and economic analysis of performance evaluation of all the thermal power plants: A review, Energy science & engineering, vol. 7, pp. 30– 65. [2] Naeimi, A., et al. (2019), Design and exergy analysis of waste heat recovery system and gas engine for power generation in Tehran cement factory, Thermal Science and Engineering Progress, vol. 9, pp. 299-307. [3] Ikedi, C.U., et al. (2016), Numerical assessment of energy contribution by building integrated photovoltaics in a commercial/office building refurbishment in UK, International Journal of Low-Carbon Technologies, vol. 11, no. 3, pp. 338–348. [4] Pourkiaei, S.M., et al. (2016), Modeling and experimental verification of a 25W fabricated PEM fuel cell by parametric and GMDH-type neural network, Mechanics & Industry, vol. 105, pp. 1-11. [5] Mehrpooya, M., et al. (2019), Technical performance analysis of a combined cooling heating and power (CCHP) system based on solid oxide fuel cell (SOFC) technology – A building application, Energy Conversion and Management, vol. 198, pp. 111767. [6] Wongchanapai, et al. (2013), Performance evaluation of a direct-biogas solid oxide fuel cell-micro gas turbine (SOFC-MGT) hybrid combined heat and power (CHP) system, Journal of Power sources, vol. 223, no. 1, pp. 9-17. [7] Hagen, et al. (2017), SOFC Operation with Real Biogas, Fuel Cells, vol. 17, no. 6, pp. 854-861. [8] Ramírez-Minguela, et al. (2018), Energy and entropy study of a SOFC using biogas from different sources considering internal reforming of methane, International Journal of Heat and Mass Transfer, vol. 120, pp. 1044-1054. [9] Ghaffarpour, et al. (2018), Thermoeconomic assessment of a novel integrated biomass based power generation system including gas turbine cycle, solid oxide fuel cell and Rankine cycle, Energy Conversion and Management, vol. 161, no. 1, pp. 1-12. [10] Paolo S., et al. (2017), Biomethane production tests on ensiled orange peel waste, international journal of heat an technology, vol. 35, pp. 130-136. [11] Malaguti, V., et al. (2017), Dynamic behavior investigation of a micro biomass CHP system for residential use, , international journal of heat an technology, vol. 35, pp. 172-178. [12] Kubba, S. (2012), Handbook of Green Building Design and Construction, Butterworth-Heinemann, ISBN: 978-0-12-385128-4. [13] Chen X. Y., et al. (2015), Membrane gas separation technologies for biogas upgrading, RSC Advances., vol. 5, pp. 24399-24448. [14] Wittchen, K.B., Aggerholm, S. (2000), Calculation of building heating demand in EPIQR, Energy and Buildings, pp. 137-141. [15] Zink, F., Lu, Y., Schaefer, L. (2007), A solid oxide fuel cell system for buildings. Journal of Energy Conversion and Management, vol. 48, pp. 809-818. [16] Chan, S.H., et al. (2007), Energy and exergy analysis of a simple SOFC power system, Journal of Power Sources, 103, no.2, pp. 188-200. [17] Larminie, J. and Dicks, A. (2003), Fuel cell systems explained, Chichester, West Sussex, John Wiley. [18] Costamagna, P., et al. (2001), Design and part load performance of a hybrid system based on a SOFC reactor and a micro GT. Journal of Power Sources, vol. 96, no. 2, pp. 352-368. [19] Chan ,S. H., et al. (2002), Modelling of Simple Hybrid Solid Oxide Fuel Cell and Gas Turbine Power Plant, Journal of Power Sources, vol. 109, no. 1, pp. 111-120. [20] Volkan Akkaya (2007), Electrochemical Model for Performance Analysis of a Tubular SOFC, International Journal of Energy Research, vol. 31, pp 79-98. [21] Zabihian, F., Fung, A.S. (2013), Performance analysis of hybrid solid oxide fuel cell and gas turbine cycle: Application of alternative fuels, Energy Conversion and Management, vol. 76, pp. 571-580. | ||
|
آمار تعداد مشاهده مقاله: 1,692 تعداد دریافت فایل اصل مقاله: 766 |
||