Energy and Exergy Assessment of a New Heat Recovery Method in a Cement Factory | ||
| Renewable Energy Research and Applications | ||
| مقاله 12، دوره 1، شماره 1، فروردین 2020، صفحه 123-134 اصل مقاله (1.28 M) | ||
| نوع مقاله: Original Article | ||
| شناسه دیجیتال (DOI): 10.22044/rera.2020.9123.1017 | ||
| نویسندگان | ||
| M. Jalili1؛ R. Cheraghi1؛ M. M. Reisi2؛ R. Ghasempour* 3 | ||
| 1Renewable enegies and environmental engineering Department, Faculty of new Sciences and Technologies,University of Tehran, Tehran, Iran. | ||
| 2Faculty of Mechanical Engineering, Shahrood University of Technology, Shahrood, Iran.t | ||
| 3Renewable enegies and environmental engineering Department, Faculty of new Sciences and Technologies,University of Tehran, Tehran, Iran.. | ||
| چکیده | ||
| Cement plants are one of the massive energy consumers and greenhouse gas producers. Processes that are carried out in a cement factory have considerable energy losses which are mostly happening because of exhausted gases and airflow for cooling the clinker. Energy consumption in a regular plant is 25% electrical and 75% thermal. Therefore, the main goal of this study is to represent a thermal recycling system in cement plants to generate power from high-temperature exhaust gases from the preheater and cooler’s high-temperature air. Thermodynamic analysis has been carried out by EES software and exergy efficiency and exergy destruction of each component of the system have been obtained. Moreover, a parametric study on the suggested cycle has been used which obtained results shows that if the input temperature and pressure of turbines get closer to the critical point of the expanded working fluid in turbines, the rate of net output work increases which lead to increasing of exergy efficiency of the whole system. The increased network of the cycle was almost 20% which would rise from 3497 kW to 4186 kW and exergy efficiency would rise from 38% to 45.94%. | ||
| کلیدواژهها | ||
| Exergy efficiency؛ Exergy destruction؛ Cement Industry؛ CO2 emissions | ||
| مراجع | ||
|
[1] Mohammadi, Amin, Muhammad Ali Ashjari, and Amirhassan Sadreddini. "Exergy analysis and optimisation of waste heat recovery systems for cement plants."International Journal of Sustainable Energy 37, No. 2 (2018): 115-133.
[2] Ramezanizadeh, Mahdi, Mohammad Alhuyi Nazari, Mohammad Hossein Ahmadi, and Lingen Chen. "A review on the approaches applied for cooling fuel cells." International Journal of Heat and Mass Transfer 139 (2019): 517-525.
[3] Ahmadi, Mohammad Hossein, Mahdi Ramezanizadeh, Mohammad Alhuyi Nazari, Giulio Lorenzini, Ravinder Kumar, and Ravindra Jilte. "Applications of nanofluids in geothermal: A review." Mathematical Modelling of Engineering Problems 5, No. 4 (2018): 281-285.
[4] I. E. A. Peter Levi, “IEA Technology Roadmap, The global iron and steel sector,” (2019).
[5] Hasanbeigi, Ali, Lynn Price, Hongyou Lu, and Wang Lan. "Analysis of energy-efficiency opportunities for the cement industry in Shandong Province, China: A case study of 16 cement plants." Energy 35, No. 8 (2010): 3461-3473.
[6] Söğüt, Ziya, Zuhal Oktay, and Hikmet Karakoç. "Mathematical modeling of heat recovery from a rotary kiln." Applied thermal engineering 30, No. 8-9 (2010): 817-825.
[7] Khurana, Shaleen, Rangan Banerjee, and Uday Gaitonde. "Energy balance and cogeneration for a cement plant." Applied Thermal Engineering 22, No. 5 (2002): 485-494.
[8] Worrell, Ernst, Lynn Price, Nathan Martin, Chris Hendriks, and Leticia Ozawa Meida. "Carbon dioxide emissions from the global cement industry." Annual review of energy and the environment 26, No. 1 (2001): 303-329.
[9] Karellas, S., A-D. Leontaritis, G. Panousis, E. Bellos, and E. Kakaras. "Energetic and exergetic analysis of waste heat recovery systems in the cement industry." Energy 58 (2013): 147-156.
[10] Naqi, Ali, and Jeong Gook Jang. "Recent progress in green cement technology utilizing low-carbon emission fuels and raw materials: A review." Sustainability 11, No. 2 (2019): 537.
[11] Madlool, Naseer Abboodi, Rahman Saidur, M. Shouquat Hossain, and Nasrudin Abd Rahim. "A critical review on energy use and savings in the cement industries." Renewable and Sustainable Energy Reviews 15, No. 4 (2011): 2042-2060.
[12] Legmann, Hilel. "Recovery of industrial heat in the cement industry by means of the ORC process." In IEEE-IAS/PCS 2002 Cement Industry Technical Conference. Conference Record (Cat. No. 02CH37282), pp. 29-35. IEEE, 2002.
[13] Saneipoor, P., G. F. Naterer, and I. Dincer. "Heat recovery from a cement plant with a Marnoch Heat Engine." Applied Thermal Engineering 31, No. 10 (2011): 1734-1743.
[14] Ahamed, Jamal Uddin, N. A. Madlool, Rahman Saidur, M. I. Shahinuddin, A. Kamyar, and Haji Hassan Masjuki. "Assessment of energy and exergy efficiencies of a grate clinker cooling system through the optimization of its operational parameters." Energy 46, No. 1 (2012): 664-674.
[15] Kaşka, Önder. "Energy and exergy analysis of an organic Rankine for power generation from waste heat recovery in steel industry." Energy Conversion and Management 77 (2014): 108-117.
[16] Larsen, Ulrik, Leonardo Pierobon, Fredrik Haglind, and Cecilia Gabrielii. "Design and optimisation of organic Rankine cycles for waste heat recovery in marine applications using the principles of natural selection." Energy 55 (2013): 803-812.
[17] Wang, Jiangfeng, Yiping Dai, and Lin Gao. "Exergy analyses and parametric optimizations for different cogeneration power plants in cement industry." Applied Energy 86, No. 6 (2009): 941-948.
[18] Zeeshan, Muhammad, and Muhammad Naeem Arbab. "Waste heat recovery and its utilization for electric power generation in cement industry." International Journal of Engineering and Technology 15 (2015).
[19] Amiri, Ali, and Mohammad Rahim Vaseghi. "Waste heat recovery power generation systems for cement production process." IEEE Transactions on Industry Applications 51, No. 1 (2014): 13-19.
[20] Abdollahpour Amir, Ghasempour Roghayeh, Kasaeian Alibakhsh, H. Ahmadi Mohammad , " Exergoeconomic analysis and optimization of a transcritical CO2 power cycle driven by solar energy based on nanofluid with liquefied natural gas as its heat sink" Journal of Thermal Analysis and Calorimetry 139, No. 1 (2020) : 451–473.
[21] Chen, Yang, P. Lundqvist, Anders Johansson, and P. Platell. "A comparative study of the carbon dioxide transcritical power cycle compared with an organic Rankine cycle with R123 as working fluid in waste heat recovery." Applied thermal engineering 26, No. 17-18 (2006): 2142-2147.
[22] Liu, Bo-Tau, Kuo-Hsiang Chien, and Chi-Chuan Wang. "Effect of working fluids on organic Rankine cycle for waste heat recovery." Energy 29, No. 8 (2004): 1207-1217.
[23] Hung, Tzu-Chen. "Waste heat recovery of organic Rankine cycle using dry fluids." Energy Conversion and management 42, No. 5 (2001): 539-553.
[24] Ahmadi, Mohammad, Mirhadi Sadaghiani, Fathollah Pourfayaz, Mahyar Ghazvini, Omid Mahian, Mehdi Mehrpooya, and Somchai Wongwises. "Energy and exergy analyses of a solid oxide fuel cell-gas turbine-organic Rankine cycle power plant with liquefied natural gas as heat sink." Entropy 20, No. 7 (2018): 484.
[25] Mohammadi, Amin, Mohammad Hossein Ahmadi, Mokhtar Bidi, Mahyar Ghazvini, and Tingzhen Ming. "Exergy and economic analyses of replacing feedwater heaters in a Rankine cycle with parabolic trough collectors." Energy Reports 4 (2018): 243-251.
[26] Wang, Huarong, Jinliang Xu, Xufei Yang, Zheng Miao, and Chao Yu. "Organic Rankine cycle saves energy and reduces gas emissions for cement production." Energy 86 (2015): 59-73. | ||
|
آمار تعداد مشاهده مقاله: 1,653 تعداد دریافت فایل اصل مقاله: 846 |
||