Experimental Investigation of Usability of Construction Waste as Aggregate | ||
| Journal of Mining and Environment | ||
| مقاله 5، دوره 12، شماره 1، فروردین 2021، صفحه 63-76 اصل مقاله (10.43 M) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22044/jme.2021.10309.1976 | ||
| نویسندگان | ||
| G. Kulekci* 1؛ A. Osman Yilmaz2؛ M. Çullu3 | ||
| 1Department of Mining Engineering Gumushane, Faculty of Engineering and Natural Sciences, Gumushane University, Gumushane, Turkey | ||
| 2Department of Mining Engineering, Karadeniz Technical University, Trabzon, Turkey | ||
| 3Department of Civil Engineering, Faculty of Engineering and Natural Sciences, Gumushane University, Gumushane, Turkey | ||
| چکیده | ||
| The aim of this work is to obtain recycled aggregate (RA) from construction debris in order to reduce the rapid consumption of aggregate resources and the environmental impact of these resources. In order to fulfill this aim, the density, porosity, Schmidt hardness test, uniaxial compression resistance, carbonation depth, and ultrasonic p-wave velocity experiments were conducted on different construction debris transported by trucks from 9 different points in Turkey. In addition, the debris samples taken were broken down to the size of the aggregate and subjected to the tests of density, porosity, moisture content, freeze-thaw, and impact resistance. As a result of the conducted experiments, the lowest mass loss as a result of freezing-thawing was in GRA with 9.36%, the highest mass loss was in ORA with 22.58%, the highest ORA average aggregate impact strength index was 21.27%, and the lowest TRA aggregate impact strength index was found to be 18.26%. İt was determined that most of the physical properties of RA obtained from the construction wreckage was within the limit values specified in the literature and that the recycled aggregates could be used instead of natural aggregate. With this work and these results, RA obtained could be used in many areas such as concrete aggregate in the construction sector, underground filling in mining, filling material in gunned concrete, and filling materials on highways. | ||
| کلیدواژهها | ||
| Aggregates؛ Recycled Aggregate؛ Construction and Wreckage Wastes؛ Durability-related properties؛ Electrical properties | ||
| مراجع | ||
|
[1]. Zawawi, M. N. A. A., Muthusamy, K., Majeed, A., Musa, R. M., Budiea, A. M. A., 2020. Mechanical properties of oil palm waste lightweight aggregate concrete with fly ash as fine aggregate replacement, Journal of Building Engineering 27, 100924.
[2]. Barani, K., Esmaili, H., 2016. Production of artificial stone slabs using waste granite and marble stone sludge samples, Journal of Mining and Environment, 7(1), 135-141. doi: 10.22044/jme.2016.491
[3]. Samton, G., 2003. Construction and Demolition Waste Manual, City of New York.
[4]. Demir, İ., 2009, The Use of Demolition Waste in Concrete Production and Its Effect on Physical and Mechanical Properties, AKU Journal of Science and engineering 02 105 -114.
[5]. Rao, A., Jha, K.N., Misra, S., 2007. Use of Aggregates From Recycled Construction and Demolition Waste in Concrete, Resources, Conservation and Recycling, 50, 71-81. [6]. Ashish, K. S., Prabir, K. S., 2018. Durability characteristics of concrete using ferronickel slag fine aggregate and fly ash, Magazine of Concrete Research 70(17), 865–874, https://doi.org/10.1680/jmacr.17.00260
[7]. Santos, S. M. N., Poulikakos, L. D., 2015. From virgin to recycled bitumen: A microstructural view, Composites Part B 80, 177e185.
[8]. Soleimanbeigi, A., Edil, T. B., Benson, C. H., 2014. Engineering Properties of Recycled Materials for Use as Embankment Fill, Geotechnical Special Publication, Geo-Congress Technical Papers,234, DOI:10.1061/9780784413272.353
[9]. Soleimanbeigi, A., Edil, T. B., Benson, C. H., 2013. Evaluation of fly ash stabilization of recycled asphalt shingles for use in structural fills, J. Mater. Civil Eng., 25(1), 94-104.
[10]. Soleimanbeigi, A., Edil, T., Tinjum, J., 2013. Effect of temperature on shear strength of recycled asphalt shingles., J. Trans. Research Board, 2349, 55-62.
[11]. Bideci, Ö. S., Bideci, A., Gültekin, A. H., Oymael, S., Yildirim, H., 2014. Polymer coated pumice aggregates and their properties, Composites: Part B 67, 239–243.
[12]. Coppola, B., Courard, L., Michel, F., Loredana, I., Luciano, D. M., 2016. Investigation on the use of foamed plastic waste as natural aggregates replacement in lightweight mortar, Composites Part B 99- 75e83
[13]. Eric, A. O., and Stephen, O. E., 2020. A review on the reactivation of hardened cement paste and treatment of recycled aggregates, Magazine of Concrete Research, 72(10), 526–539, https://doi.org/10.1680/jmacr.18.00452
[14]. Topçu, İ. B., and Güncan, F. N., 1995. Using Waste Concrete as Aggregate. Cem Concr Res., 25, 7, 1385-1390.
[15]. Poon, C. S., 1997. Management and Recycling of Demolition Waste in Hong Kong, Waste Management & Research, 15, 561-572.
[16]. Poon, C. S., Qiao, X. C. and Chan, D., 2006. The Cause and Influence of Self-Cementing Properties of Waste Recycled Concrete Aggregates in the Properties of Unbound Sub-Base, Waste Management, 26, 1166-1172.
[17]. Thomas, C., Cimentada, A., Polanco, J. A., Setién J., Méndez, D., Rico, J., 2013. Influence of recycled aggregates containing sulphur on properties of recycled aggregate mortar and concrete, Composites: Part B 45, 474–485.
[18]. Colangelo, F., Cioffi, R., Liguori, B., Iucolano, F., 2016. Recycled polyolefins waste as aggregates for lightweight concrete Composites Part B 106, 234e241.
[19]. Rakshvir, M., and Barai, S.V., 2006. Studies on Recycled Aggregates-Based Concrete, Waste Manage Res, 24, 225-233.
[20]. Yan, K., Li, G., You, L., Zhou ,Y., Wu, S., 2020. Performance assessments of open-graded cement stabilized macadam containing recycled aggregate Construction and Building Materials ,233, 10 117326. https://doi.org/10.1016/j.conbuildmat.2019.117326
[21]. Kawale, A. P., Umare, M., Shende, A., 2020. Effect Of Substitution Of Fine Aggregate And Coarse Aggregate With Factory Waste And Construction Waste On Compressive Strength Of Concrete Journal of Seybold Report 15 -9.
[22]. Iskender, E., 2013. Rutting evaluation of stone mastic asphalt for basalt and basalt–limestone aggregate combinations, Composites: Part B 54, 255–264.
[23]. Xiao, R., Polaczyk, P., Zhang, M., et al. 2020. Evaluation of Glass Powder-Based Geopolymer Stabilized Road Bases Containing Recycled Waste Glass Aggregate. Transportation Research Record. 2674(1):22-32. doi:10.1177/0361198119898695
[24]. Silva, A. F., Santos, G. J., Moizinho, J. C., Araujo, Y. C. F., 2020. Recycling of construction and demolition waste as aggregate for pavement block production, La Revista AIDIS de Ingeniería y Ciencias Ambientales 13 (1).
[25]. Khalaf, F.M., and De Venny, A. S., 2004. Recycling of demolished masonry rubble as course aggregate in concrete: review, ASCE Journal of Material In Civil Engineering, 16:331-340.
[26]. Gonçalves, P. and Brito, J., 2010. Recycled aggregate concrete (RAC) – comparative analysis of existing specifications, Magazine of Concrete Research, 62:339-346.
[27]. Evangelista, L., J. de Brito, 2010. Durability performance of concrete made with fine recycled concrete aggregates, Cem. Concr. Compos. 32 (1) 9–14.
[28]. Le, M.T., Tribout, C., Escadeillas, G., 2019. Durability of mortars with leftover recycled sand, Construction and Building Materials, 215, Pages 391-400.
[29]. Vo, D-H., Yehualaw, M.D., Hwang, C-L., Liao, M-C., Tran, Thi K-D., Chao, Y-F., 2021. Mechanical and durability properties of recycled aggregate concrete produced from recycled and natural aggregate blended based on the Densified Mixture Design Algorithm method, Journal of Building Engineering, Vol.35, 102067.
[30]. ASTM C 805., 2004. Standard Test Method for Rebound Number of Hardened Concrete. Annual Book of ASTM Standards, 4(2), 1-3. Philadelphia, USA.
[31]. ASTM C 597. 2004. Standard Test Method for Pulse Velocity Through Concrete. Annual Book of ASTM Standards, 4(2), 1-4. Philadelphia, USA.
[32]. TS EN 12390–3.2014. Testing hardened concrete - Part 3: Compressive strength of test specimens, Turkish Standardization Institute, Ankara.
[33]. TS EN 1097-6, 2013. Tests for mechanical and physical properties of aggregates- Part 6: Determination of particle density and water absorption, Turkish Standardization Institute, Ankara, 1-12 .
[34]. TS EN 1367-1, 2008. Tests for thermal and weathering properties of aggregates - Part 1: Determination of resistance to freezing and thawing, Turkish Standardization Institute, Ankara, 1-12.
[35]. TS EN 1097–2, 2000. Tests for mechanical and physical properties of aggregates - Part 2: Methods for the determination of resistance to fragmentation, Turkish Standardization Institute, Ankara,.
[36]. TS 500, 2001. Requirements for design and construction of reinforced concrete structures, Turkish Standardization Institute, Ankara.
[37]. BS 812: Part 112, 1990. Testing Aggregates. Method for Determination of Aggregate Impact Value
[38]. TS 3814 EN 933–4, 2001. Tests for geometrical properties of aggregates- Part 4: Determination of particle shape- Shape index’’, Turkish Standardization Institute, Ankara.
[39]. Erdoğan, Y, T., 2003. Beton, Metu, Ankara.
[40]. Durmuş, G., Şimşek, O., and Dayı, M., 2009. The effects of coarse recycled concrete aggregates on concrete propertıes, J. Fac. Eng. Arch. Gazi Univ. 24(1), 183-189. | ||
|
آمار تعداد مشاهده مقاله: 799 تعداد دریافت فایل اصل مقاله: 600 |
||