Rock Fall Hazard Assessment using GeoRock 2D along Swat Motorway, Pakistan | ||
| Journal of Mining and Environment | ||
| مقاله 5، دوره 12، شماره 2، تیر 2021، صفحه 351-365 اصل مقاله (5.03 M) | ||
| نوع مقاله: Short Communication | ||
| شناسه دیجیتال (DOI): 10.22044/jme.2021.10599.2011 | ||
| نویسندگان | ||
| M. Adil* ؛ S. Raza؛ I. Amin | ||
| Department of Mining Engineering, University of Engineering and Technology, Peshawar, Khyber Pakhtunkhwa, Pakistan | ||
| چکیده | ||
| Despite the slope stability measures, rock falls are witnessed at section KM-37 of the Swat motorway (M-16), Khyber Pakhtunkhwa, Pakistan. The geotechnical data analysis of the site reveals that although the chances of plane/slope failures are reduced from 43% to 23% with the help of the existing design, still there are possibilities of rock fall at the sight, which has also been witnessed during the field visits. The rock fall hazards are assessed through field tests and simulation, and significant stabilization measures are suggested. The rock fall tests are conducted, and then using the data obtained, the rock fall simulation is carried out using GeoRock 2D®. From a combination of the kinematic analysis and rock fall simulation, the hazard level along the slope ranges from moderate to high. The reason for this is the increasing velocity of the falling boulder and the impact of energy at the bottom of the slope. This is an indication of the risk, as the most hazardous area is at the toe of the slope, where the highway road is the main element at risk. Rock boulders of different shapes and sizes are released from a couple of benches in order to check their impacts on the highway. Based on the simulation, it is concluded that the spherical shaped boulders are released from higher benches covering more horizontal distances and reaching the highway with a higher bouncing heights at the toe of the slope than the cylindrical shaped boulders. The maximum bounce height of 7 m has been recorded at the toe of the slope. In order to reduce the impacts of energy and bounce heights of the boulders striking the slope surface, certain mitigation measures are suggested like a ditch of a specific size filled with sand or fine debris at the toe of the slope. Draping wire mesh on the slope surface and a retaining wall or fence would be greatly helpful and economical to reduce the rock falling hazards along the road side at section KM-37 of the Swat motorway. | ||
| کلیدواژهها | ||
| Rock fall Simulation؛ Hazards Assessment؛ Highway؛ Slope Stability؛ Swat Motorway | ||
| مراجع | ||
|
[1]. Sazid, M. (2019). Analysis of rockfall hazards along NH-15: A case study of Al-Hada road. International Journal of Geo-Engineering. 10 (1): 1-13.
[2]. Katz, O., Reichenbach, P. and Guzzetti, F. (2011). Rock fall hazard along the railway corridor to Jerusalem, Israel, in the Soreq and Refaim valleys. Natural hazards. 56 (3): 649-665.
[3]. Wieczorek, G.F., Stock, G.M., Reichenbach, P., Snyder, J.B., Borchers, J.W. and Godt, J.W. (2008). Investigation and hazard assessment of the 2003 and 2007 Staircase Falls rock falls, Yosemite National Park, California, USA. Natural Hazards and Earth System Sciences. 8 (3): 421-432.
[4]. Regmi, A. D., Cui, P., Dhital, M. R., & Zou, Q. (2016). Rock fall hazard and risk assessment along Araniko Highway, Central Nepal Himalaya. Environmental Earth Sciences. 75 (14): 1-20.
[5]. Guzzetti, F., Reichenbach, P. and Wieczorek, G.F. (2003). Rockfall hazard and risk assessment in the Yosemite Valley, California, USA. Natural Hazards and Earth System Sciences. 3 (6): 491-503.
[6]. F. Guzzetti et al., “STONE : a computer program for the 3D simulation of rock-falls $,” Vol. 28, pp. 1079–1093, 2002.
[7]. Youssef, A.M. and Maerz, N. H. (2009). Slope stability hazard assessment and mitigation methodology along eastern desert Aswan-Cairo highway, Egypt. Earth Sciences, 20(2).
[8]. Tagliavini, F., Reichenbach, P., Maragna, D., Guzzetti, F. and Pasuto, A. (2009). Comparison of 2-D and 3-D computer models for the M. Salta rock fall, Vajont Valley, northern Italy. Geoinformatica, 13(3), 323-337.
[9]. Khaliq, A.H., Waseem, M., Khan, S., Ahmed, W. and Khan, M.A. (2019). Probabilistic seismic hazard assessment of Peshawar District, Pakistan. Journal of Earth System Science, 128(1), 1-22.
[10]. F. Report, 4 4.1 Geology and Tectonics, No. March. 1998.
[11]. M.Q.J.A.H. Kazmi, “Geology Tectonics of Pakistan.”.
[12]. San, N.E., Topal, T. and Akin, M.K. (2020). Rockfall Hazard Assessment Around Ankara Citadel (Turkey) Using Rockfall Analyses and Hazard Rating System. Geotechnical and Geological Engineering, 1-21.
[13]. Palma, B., Parise, M., Reichenbach, P. and Guzzetti, F. (2012). Rockfall hazard assessment along a road in the Sorrento Peninsula, Campania, southern Italy. Natural Hazards. 61 (1): 187-201.
[14]. R. Mass, S. Analysis, and G. Hoek-brown, “Data Input / Output : Hoek-Brown Input and Output Parameters.”
[15]. Mineo, S., Pappalardo, G., Mangiameli, M., Campolo, S. and Mussumeci, G. (2018). Rockfall analysis for preliminary hazard assessment of the cliff of Taormina Saracen Castle (Sicily). Sustainability, 10 (2): 417.
[16]. Costa Silveira, L. R. and Lana, M.S. (2018). Rockfall Hazard Assessment Approach for Slopes in a Quartzite Mine. In ISRM VIII Brazilian Symposium on Rock Mechanics-SBMR 2018. International Society for Rock Mechanics and Rock Engineering.
[17]. Akin, M., Dinçer, İ., Ok, A. Ö., Orhan, A., Akin, M. K. and Topal, T. (2021). Assessment of the effectiveness of a rockfall ditch through 3-D probabilistic rockfall simulations and automated image processing. Engineering Geology, 283, 106001.
| ||
|
آمار تعداد مشاهده مقاله: 683 تعداد دریافت فایل اصل مقاله: 627 |
||