Investigation of Arc Angle Rotor Blade Variations Effect of Savonius Vertical Axis Wind Turbine on Power and Torque Coefficients Using a 3D Modeling | ||
| Renewable Energy Research and Applications | ||
| دوره 4، شماره 1، فروردین 2023، صفحه 13-19 اصل مقاله (470.22 K) | ||
| نوع مقاله: Original Article | ||
| شناسه دیجیتال (DOI): 10.22044/rera.2022.11282.1084 | ||
| نویسندگان | ||
| M. Akhlaghi* 1؛ F. Ghafoorian2 | ||
| 1Assistant Professor, Manager, Turbomachinery Research Laboratory, Department of Energy Conversion, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran. | ||
| 2MSc Student, Turbomachinery Research Laboratory, Department of Energy Conversion, School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran. | ||
| چکیده | ||
| Unacceptable air pollution leads to a remarkable increase in the consumption of renewable energy. Wind energy is known as one of the conventional renewable sources, therefore installation of wind turbines has increased over the past three decades. Savonius wind turbine is one of the types of vertical axis wind turbines. This type has many advantages namely low noise, self-start capability and closer spacing. Some studies has been carried out to increase the efficiency of wind turbines by optimizing the geometry. In the present study, the arc angle of Savonius turbine blades and its effects as one of the geometric parameters affecting the efficiency of the turbine have been investigated within a CFD method. The amount of arc angle, also called camber angle, is very effective in the optimal efficiency of Savonius wind turbine. To investigate this issue, three different arc angles in the different tip speed ratios have been evaluated. The values of power and torque coefficients which play a vital role in the efficiency of the above turbine have been considered with respect to the changes in the amount of three different arc angle. The results of three-dimensional numerical solution show that the highest power and torque coefficients are obtained with values (0.0261) and (0.501) at a 180 degree arc angle, respectively. Adopting values other than the above value will cause a significant drop in efficiency. | ||
| کلیدواژهها | ||
| Vertical axis wind turbine؛ Savonius wind turbine؛ Power coefficient؛ Torque coefficient؛ Tip speed Ratio | ||
| مراجع | ||
|
[1] S. L. Dixon and C. A. Hall, Fluid mechanics and thermodynamics of turbomachinery, Seventh edition. Amsterdam ; Boston: Butterworth-Heinemann is an imprint of Elsevier, 201
4.
[2]R. Alayi, S. R. Seyednouri, M. Jahangiri, and A. Ma’arif, “Optimization, Sensitivity Analysis, and Techno-Economic Evaluation of a Multi-Source System for an Urban Community: a Case Study,” p. 10.
[3]M. M. Aslam Bhutta, N. Hayat, A. U. Farooq, Z. Ali, Sh. R. Jamil, and Z. Hussain, “Vertical axis wind turbine – A review of various configurations and design techniques,” Renewable and Sustainable Energy Reviews, Vol. 16, No. 4, pp. 1926–1939, May 2012, doi: 10.1016/j.rser.2011.12.004.
[4] A. Alaimo, A. Esposito, A. Messineo, C. Orlando, and D. Tumino, “3D CFD Analysis of a Vertical Axis Wind Turbine,” Energies, Vol. 8, No. 4, pp. 3013–3033, Apr. 2015, doi: 10.3390/en8043013.
[5] S. Brusca, R. Lanzafame, and M. Messina, “Design of a vertical-axis wind turbine: how the aspect ratio affects the turbine’s performance,” Int J Energy Environ Eng, Vol. 5, No. 4, pp. 333–340, Dec. 2014, doi: 10.1007/s40095-014-0129-x.
[6] N. M. Ali, “The Effect of Darrieus and Savonius Wind Turbines Position on The Performance of The Hybrid Wind Turbine at Low Wind Speed,” p. 17.
[7] J. Velarde, C. Kramhøft, and J. D. Sørensen, “Global sensitivity analysis of offshore wind turbine foundation fatigue loads,” Renewable Energy, Vol. 140, pp. 177–189, Sep. 2019, doi: 10.1016/j.renene.2019.03.055.
[8] O. S. Mohamed, A. A. Ibrahim, A. K. Etman, A. A. Abdelfatah, and A. M. R. Elbaz, “Numerical investigation of Darrieus wind turbine with slotted airfoil blades,” Energy Conversion and Management: X, Vol. 5, p. 100026, Jan. 2020, doi: 10.1016/j.ecmx.2019.100026.
[9] S. S. Dol, A. Khamis, M. T. Abdallftah, M. Fares, and S. S. Pervaiz, “CFD Analysis of Vertical Axis Wind Turbine with Winglets,” Renewable Energy Research and Applications, 2021, doi: 10.22044/rera.2021.11122.1074.
[10] B. Hand, “A review on the historical development of the lift-type vertical axis wind turbine_ From onshore to offshore floating application,” Sustainable Energy Technologies and Assessments, p. 11, 2020.
[11] R. D. Maldonado, “Design, Simulation and Construction of a Savonius Wind Rotor for Subsidized Houses in Mexico,” Energy Procedia, p. 7, 2014.
[12] A. Pallotta, D. Pietrogiacomi, and G. P. Romano, “HYBRI – A combined Savonius-Darrieus wind turbine: Performances and flow fields,” Energy, Vol. 191, p. 116433, Jan. 2020, doi: 10.1016/j.energy.2019.116433.
[13] V. Jayaram, “A brief review on the Gorlov helical turbine and its possible impact on power generation in
India,” Materials Today, p. 9.
[14] M. H. Ali, “Experimental Comparison Study for Savonius Wind Turbine of Two & Three Blades At Low Wind Speed,” Vol. 3, No. 5, p. 9, 2013.
[15] M. Zemamou, M. Aggour, and A. Toumi, “Review of savonius wind turbine design and performance,” Energy Procedia, vol. 141, pp. 383–388, Dec. 2017, doi: 10.1016/j.egypro.2017.11.047.
[16] I. B. Alit, “Effect of Overlapping Ratio, Blade Shape Factor, and Blade Arc Angle to modified Rotor Savonius performances,” Vol. 13, No. 1, p. 6, 2018.
[17] N. Mishra, A. Jain, A. Nair, B. Khanna, and S. Mitra, “Experimental Investigation on a Ducted Savonius Vertical Axis Wind Turbine and its Performance Comparison with and without Endplates,” Renewable Energy Research and Application, Vol. 1, No. 1, Nov. 2019, doi: 10.22044/rera.2019.8533.1005.
[18] M. Ebrahimpour, R. Shafaghat, R. Alamian, and M. Safdari Shadloo, “Numerical Investigation of the Savonius Vertical Axis Wind Turbine and Evaluation of the Effect of the Overlap Parameter in Both Horizontal and Vertical Directions on Its Performance,” Symmetry, Vol. 11, No. 6, p. 821, Jun. 2019, doi: 10.3390/sym11060821.
[19] D. Borzuei, S. F. Moosavian, and M. Farajollahi, “On the Performance Enhancement of the Three-Blade Savonius Wind Turbine Implementing Opening Valve,” Journal of Energy Resources Technology, p. 11.
[20] U. K. Saha, S. Thotla, and D. Maity, “Optimum design configuration of Savonius rotor through wind tunnel experiments,” Journal of Wind Engineering and Industrial Aerodynamics, Vol. 96, No. 8–9, pp. 1359–1375, Aug. 2008, doi: 10.1016/j.jweia.2008.03.005.
[21] Z. Mao and W. Tian, “Effect of the blade arc angle on the performance of a Savonius wind turbine,” Advances in Mechanical Engineering, Vol. 7, No. 5, p. 168781401558424, May 2015, doi: 10.1177/1687814015584247.
[22] M. Moghimi and H. Motawej, “Developed DMST model for performance analysis and parametric evaluation of Gorlov vertical axis wind turbines,” Sustainable Energy Technologies and Assessments, Vol. 37, p. 100616, Feb. 2020, doi: 10.1016/j.seta.2019.100616.
[23] J. V. Akwa, H. A. Vielmo, and A. P. Petry, “A review on the performance of Savonius wind turbines,” Renewable and Sustainable Energy Reviews, Vol. 16, No. 5, pp. 3054–3064, Jun. 2012, doi: 10.1016/j.rser.2012.02.056.
[24] A. Hosseinkhani and S. Sanaye, “Performance Prediction of a SANDIA 17-m Vertical Axis Wind Turbine Using Improved Double Multiple Streamtube,” Vol. 14, No. 12, p. 5, 2020.
[25] Q. Li, “Effect of number of blades on aerodynamic forces on a straight-bladed Vertical Axis Wind Turbine,” p. 12, 2015.
[26] J. Taghinezhad, E. Mahmoodi, M. Masdari, and R. Alimardani, “Spectral Analyses of an Optimized Ducted Wind Turbine Using Hot-wire Anemometry,” Renewable Energy Research and Application, doi: 10.22044/rera.2021.10938.1060.
[27] F. Wenehenubun, “An Experimental Study on the Performance of Savonius Wind Turbines Related With The Number Of Blades,” Energy Procedia, p. 8, 2015. | ||
|
آمار تعداد مشاهده مقاله: 2,656 تعداد دریافت فایل اصل مقاله: 934 |
||