Ahmadi, E., Norouzi, M., & Jalali, M. E. (2018). Ability of grout stone injection (Case study of Rudbar storage pump design in Lorestan), The First National Conference on Modeling in Mining Engineering, Qazvin.. (In Persian)

Amiri, M., Dousti, H. (2022). The effect of soil layering on the propagation of waves from surface explosions on buried tunnels (Case study of Isfahan metro tunnel, Sefeh-Azadi route). Journal of Tunneling and Underground Space Engineering. (In Persian)

Amiri, M., Sanjari, M., & Porhonar, F. (2022). Microstructural evaluation of the cement stabilization of hematite-rich red soil. Case Studies in Construction Materials, 16, e00935.‏

Amiri, M., Rajabi, S., & Darabi, M. (2019). Study of the Effect of Cross-sectional Geometry of Single and Twin Tunnels on the Ground Surface Settlement (Case study: Isfahan’s Metro Tunnel). Journal of civil enviromental engineering, 49.2(95), 35-46. (In Persian)

Amiri, M., Ameri Siahouri, M., Ghasemi, S., Salehian, R. (2021).  Investigation of the effect of tunnel excavation on the surrounding structures with a superior attitude on the heights and widths of the structures (Case study: Isfahan’s Metro Tunnel). Journal of Tunneling and Underground Space Engineering, 10 (1), 57-69. (In Persian)

Amiri, M., Asakereh, A., Atashpoosh, H. (2020). Investigation of strength and structure of marl soils stabilized with cement and nanosilica. Journal of Engineering Geology, 14 (1), 29-52.

Assimaki, D., Kausel, E., & Whittle, A. (2000). Model for dynamic shear modulus and damping for granular soils. Journal of Geotechnical and Geoenvironmental Engineering, 126(10), 859-869.‏

ASTM, D. (1999). Standard test method for specific gravity of soils. Test method A Procedure for Oven-Dried Specimens.

ASTM, D. (2011). Standard test method for direct shear test of soils under consolidated drained conditions. ASTM West  Conshohocken

Badaghabadi, S., Fooladchi, S., Mousavi, J. (2008). Determination of strength parameters of sandstone formations using porosity, 2nd Iranian Mining Engineering Conference, Tehran. (In Persian)  

Delfosse-Ribay, E., Djeran-Maigre, I., Cabrillac, R., & Gouvenot, D. (2004). Shear modulus and damping ratio of grouted sand. Soil Dynamics and Earthquake Engineering, 24(6), 461-471.‏

Danot, C., & Derache, N. (2007, November). Grout injection in the laboratory. In International Symposium on Earth Reinforcement (pp. 14-16).‏

Dano, C., & Hicher, P. Y. (2003). Behavior of uncemented sands and grouted sands before peak strength. Soils and foundations, 43(4), 13-19.‏

Doroodian, B., Ahangari, K., & Noorzad, A. (2022). Damage caused by mechanized tunnel boring in high-stress hard rock. Transportation Geotechnics, 34, 100741.‏

Du, Q., Pan, T., Lv, J., Zhou, J., Ma, Q., & Sun, Q. (2019). Mechanical properties of sandstone cement-stabilized macadam. Applied Sciences, 9(17), 3460.‏

Hashemi Hafdani, M. (2002). Using High Pressure Injection Method for Soil Improvement in Tunneling Issues, Fifth Iran Tunnel Conference, Tehran

Javadanian, H., Haddad, A., & Jafarian, Y. (2016). Estimating the shearing modulus of Bushehr calcareous sand using resonant column and cyclic triaxial experiments. Modares Civil Engineering Journal, 9-20. (In Persian)

Konstantinou, C., Biscontin, G., Jiang, N. J., & Soga, K. (2021). Application of microbially induced carbonate precipitation to form bio-cemented artificial sandstone. Journal of Rock Mechanics and Geotechnical Engineering, 13(3), 579-592.‏

Kordnaeij, A., Ziaie Moayed, R., & Soleimani, M. (2020). Small Strain Shear Modulus of Sands Grouted with Zeolite-cement Suspension. Amirkabir Journal of Civil Engineering, 52(5), 1277-1298.‏ (In Persian)

Makram Qutourlar, N., Ghaffarpour Jahromi, S., Gotmiri, B. (2018). A review of the factors affecting the shear modulus and sand damping ratio in the cyclic triaxial experiment. Third National Conference on Geotechnical Engineering of Iran, Tehran. (In Persian)

Moomivand, H., Moomivand, H., Nikrouz, R., & Azad, R. (2022). Development of a New Empirical Relation to Assess P-wave Velocity Anisotropy of Rocks. Geotechnical and Geological Engineering, 40(3), 1537-1550.

Naraghi Araghi, N., Hashemi Tabatabai, S., & Beit Elahi, A. (2003). Comparison of shear wave velocity (VS) and destruction rate in Bam city in the earthquake of January 26, 2003. Earth, 5 (2), 109-118.

Qiyasi, V., et al., (2021). Investigation of the effect of modulus of elasticity, shear modulus, damping ratio and shear wave velocity in soil dynamic analysis. Road, 29 (108), 87-100. (In Persian)

Rahimi, H. (2014). Geotechnical Engineering, Tehran, Tehran University Publishing Institute

Rahimi, Hassan (2016). Geotechnical Engineering (Problematic Soils), Tehran, University of Tehran Publishing Institute

Sakurai, S. (1997). Lessons learned from field measurements in tunnelling. Tunnelling and underground space technology  12(4), 453-460.‏

Seiphoori, A., & Zamanian, M. (2022). Improving mechanical behaviour of collapsible soils by grouting clay nanoparticles. Engineering Geology, 298, 106538.

Yubing Yang, et al., (2010). "Numerical simulation of dynamic response of operating metro tunnel induced by ground explosion." Journal of Rock Mechanics and Geotechnical Engineering 2(4): 373-384.

Zhang, W., Han, L., Gu, X., Wang, L., Chen, F., & Liu, H. (2020). Tunneling and deep excavations in spatially variable soil and rock masses: A short review. Underground Space.‏

Zheng,  D., Tang, L., Wang, Y., & Sun, Y. (2022). Dynamic stress accumulation effects on soil strengh under cyclic loading. Soils and Foundations 62(4), 101164.

Zhang, Y., & Huang, F. (2011). Mechanism of different coseismic water-level changes in wells with similar epicentral distances of intermediate field. Bulletin of the Seismological Society of America, 101(4), 1531-1541.‏