Numerical Analysis of Strip Footing Behaviour on a Hollow Pile Stabilized Clay Slope | ||
| Journal of Mining and Environment | ||
| مقاله 5، دوره 14، شماره 3، مهر 2023، صفحه 799-811 اصل مقاله (1.29 M) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22044/jme.2023.12893.2340 | ||
| نویسندگان | ||
| Lokeshwar Singh Dilta* ؛ Ravi Kumar Sharma | ||
| Civil Engineering Department, National Institute of Technology Hamirpur, Himachal Pradesh, India | ||
| چکیده | ||
| This study highlights the results from a series of analytical model experiments that investigate the behaviour of a strip footing supported by hollow steel piles installed to stabilize a clay slope. The effects of changing the pile diameter, pile length, spacing between piles, slope angle, the position of the pile row from the top of slope, and the footing placement are all examined. After determining the load-carrying capacity of unstabilized slopes, it is compared with the load-carrying capacity of stabilized slopes. The results are then analysed to see how each parameter affects the load carrying capacity of strip footing. The results of unstabilized cases reveal that the load carrying capacity of a footing decreases as the slope angle increases and increases when the footing is positioned away from the slope. In addition, the findings imply that by reinforcing clay slope with a sequence of hollow steel piles significantly enhances the load carrying capacity of strip footing. As the distance between piles is decreased and their length is increased, the bearing capacity of the footing increases, and this improvement is enhanced by increasing the diameter of the piles. When the row of pile is positioned away from the top of the slope, the footing’s load carrying capacity decreases. Also positioning the footing a quite distance apart from the crest slope shows reduction in bearing capacity ratio. | ||
| کلیدواژهها | ||
| Load carrying capacity؛ hollow pile؛ strip footing؛ slope؛ stabilization | ||
| مراجع | ||
|
[1]. Meyerhof, G.G. (1957). The ultimate bearing capacity of foundations on slopes. In Proc., 4th Int. Conf. on Soil Mechanics and Foundation Engineering (Vol. 1, pp. 384-386).
[2]. Graham, J., Andrews, M., and Shields, D.H. (1988). Stress characteristics for shallow footings in cohesionless slopes. Canadian Geotechnical Journal, 25 (2): 238-249.
[3]. Saran, S., Sud, V.K., and Handa, S.C. (1989). Bearing capacity of footings adjacent to slopes. Journal of geotechnical engineering, 115 (4): 553-573.
[4]. Narita, K. and Yamaguchi, H. (1990). Bearing capacity analysis of foundations on slopes by use of log-spiral sliding surfaces. Soils and Foundations, 30 (3): 144-152.
[5]. Selvadurai, A.P.S. and Gnanendran, C.T. (1989). An experimental study of a footing located on a sloped fill: influence of a soil reinforcement layer. Canadian Geotechnical Journal, 26 (3): 467-473.
[6]. Yoo, C. (2001). Laboratory investigation of bearing capacity behavior of strip footing on geogrid-reinforced sand slope. Geotextiles and Geomembranes, 19 (5): 279-298.
[7]. Saleh, N.M. (2002). Behavior of footings under centric and eccentric loads adjacent to reinforced slopes. Ain Shams Univ Sci Bull, 37 (4): 41-63.
[8]. Kaur, A. and Sharma, R.K. (2016). Slope stability analysis techniques: A review. International Journal of Engineering Applied Sciences and Technology, 1 (4): 52-57.
[9]. Sharma, R.K. and Bhardwaj, A. (2019). Effect of construction demolition and glass waste on stabilization of clayey soil. In Proceedings of the 1st International Conference on Sustainable Waste Management through Design: IC_SWMD 2018 1 (pp. 87-94). Springer International Publishing.
[10]. Bhardwaj, A. and Sharma, R.K. (2020). Effect of industrial wastes and lime on strength characteristics of clayey soil. Journal of Engineering, Design and Technology.
[11]. Bhardwaj, A., Sharma, R.K., and Sharma, A. (2021). Stabilization of clayey soil using waste foundry sand and molasses. In Sustainable Development Through Engineering Innovations: Select Proceedings of SDEI 2020 (pp. 641-649). Springer Singapore.
[12]. Bhardwaj, A., and Sharma, R.K. (2022). Bearing Capacity Evaluation of Shallow Foundations on Stabilized Layered Soil using ABAQUS. Studia Geotechnica et Mechanica.
[13]. Hassiotis, S., Chameau, J.L., and Gunaratne, M. (1997). Design method for stabilization of slopes with piles. Journal of Geotechnical and Geoenvironmental Engineering, 123 (4): 314-323.
[14]. Lee, C.Y., Hull, T.S., and Poulos, H.G. (1995). Simplified pile-slope stability analysis. Computers and Geotechnics, 17 (1): 1-16.
[15]. Cai, F. and Ugai, K. (2000). Numerical analysis of the stability of a slope reinforced with piles. Soils and foundations, 40 (1): 73-84.
[16]. Ausilio, E., Conte, E., and Dente, G. (2001). Stability analysis of slopes reinforced with piles. Computers and Geotechnics, 28 (8): 591-611.
[17]. Li, R.P. (2009). Stability analysis of cutting slope reinforced with anti-slide piles by FEM. In Slope Stability, Retaining Walls, and Foundations: Selected Papers from the 2009 GeoHunan International Conference (pp. 166-173).
[18]. Haghbin, M. and Ghazavi, M. (2013). Bearing capacity of footings on pile-stabilized slopes.
[19]. Mofidi Rouchi, J., Farzaneh, O., and Askari, F. (2014). Bearing capacity of strip footings near slopes using lower bound limit analysis. Civil Engineering Infrastructures Journal, 47 (1): 89-109.
[20]. Liu, Y. and Geo, F. (2015). Dynamic stability analysis on a slope supported by anchor bolts and piles. Electronic Journal of Geotechnical Engineering, 20 (7): 1887-1900.
[21]. Day, R.W., Hull, T.S., Poulos, H.G., Hassiotis, S., Chameau, J.L., and Gunaratne, N. (1999). Design method for stabilization of slopes with piles. Journal of Geotechnical and Geoenvironmental Engineering, 125 (10): 910-914.
[22]. Poulos, H. G. (1995). Design of reinforcing piles to increase slope stability. Canadian Geotechnical Journal, 32 (5): 808-818.
[23]. Ito, T. and Matsui, T. (1975). Methods to estimate lateral force acting on stabilizing piles. Soils and foundations, 15 (4): 43-59.
[24]. Ito, T., Matsui, T., and Hong, W.P. (1979). Design method for the stability analysis of the slope with landing pier. Soils and Foundations, 19 (4): 43-57.
[25]. Ito, T., Matsui, T., and Hong, W.P. (1981). Design method for stabilizing piles against landslide—one row of piles. Soils and Foundations, 21 (1): 21-37.
[26]. Ito, T., Matsui, T., and Hong, W.P. (1982). Extended design method for multi-row stabilizing piles against landslide. Soils and foundations, 22 (1): 1-13.
[27]. Wei, W.B. and Cheng, Y.M. (2009). Strength reduction analysis for slope reinforced with one row of piles. Computers and Geotechnics, 36 (7): 1176-1185.
[28]. El Sawwaf, M.A. (2005). Strip footing behavior on pile and sheet pile-stabilized sand slope. Journal of Geotechnical and Geoenvironmental Engineering, 131 (6): 705-715.
[29]. As’ad Munawir, M.D., Zaika, Y., and Agoes Soehardjono, M.D. (2013). Bearing capacity on slope modeling with composite bamboo pile reinforcement. Jurnal Terpublikasi: International Journal of Engineering and Advanced Technology (IJEAT).
[30]. Saleh, S., Mohd Yunus, N.Z., Ahmad, K., and Mat Said, K.N. (2021). Numerical simulation with hardening soil model parameters of marine clay obtained from conventional tests. SN Applied Sciences, 3, 1-13. | ||
|
آمار تعداد مشاهده مقاله: 262 تعداد دریافت فایل اصل مقاله: 400 |
||