Performance Evaluation of Zinc Tailing Waste Material for Embankment Construction: Experimental and Numerical Investigation | ||
| Journal of Mining and Environment | ||
| مقاله 1، دوره 15، شماره 4، دی 2024، صفحه 1177-1191 اصل مقاله (9.63 M) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22044/jme.2024.13368.2459 | ||
| نویسندگان | ||
| Pankaj Bhatt* 1؛ Anil Kumar Sinha2؛ Mariya Dayana P J2؛ Parvathi Geetha Sreekantan2؛ Murtaza Hasan1 | ||
| 1Department of Civil Engineering, Chandigarh University, Mohali, India | ||
| 2CSIR-Central Road Research Institute, New Delhi, India | ||
| چکیده | ||
| The rapid development of road networks needs huge construction materials. Mining and industrial wastes can be used as sustainable road construction materials and will be alternatives to fulfill the huge demand in road construction. Zinc tailing is one such mining waste and has the potential for road construction. This material was collected from Zawar mines (Rajasthan), and characterization was carried out for embankment/subgrade applications. A physical model test was conducted in the laboratory to examine the stress-settlement behaviour. To improve the modulus value of tailing, it was reinforced with geogrid in two different laying patterns, viz. layer/loop and stress-settlement behavior was studied. Different parameters were studied: reinforcement depth, layer of reinforcement, number of loops, and depth of loop of reinforcement. The experimental result was validated with the numerical finite element method (SoilWorks). Tailing comprises fine-grained silt-size particles (61%) with no swelling behavior and non-plastic nature. It has values of MDD and OMC as 1.86 g/cm3 and 11%, respectively. It has a higher value of CBR (12%) and internal friction angle (34.6o) with cohesionless nature. The variation of settlement with stress is linear for reinforced and unreinforced tailing fill. As the depth of reinforcement increases, settlement increases in both layer and loop reinforcement. The settlement trajectory obtained from a numerical method closely resembles that of a laboratory physical model, particularly when the applied stress is up to 600 kPa. The modulus of elasticity of tailing was significantly improved with the introduction of geogrid reinforcement either in layer or loop. | ||
| کلیدواژهها | ||
| Zinc tailing؛ waste material؛ geogrid؛ embankment؛ numerical analysis | ||
| مراجع | ||
|
[1]. Esfahani, H. S., & Ramı́rez, M. T. (2003). Institutions, infrastructure, and economic growth. Journal of development Economics, 70(2), 443-477. [2]. Ghani, E., Goswami, A. G., & Kerr, W. R. (2016). Highway to success: The impact of the Golden Quadrilateral project for the location and performance of Indian manufacturing. The Economic Journal, 126(591), 317-357. [3]. Ghosh, P. K., & Dinda, S. (2022). Revisited the relationship between economic growth and transport infrastructure in India: an empirical study. The Indian Economic Journal, 70(1), 34-52. [4]. Liebenberg, J. J. E., & Visser, A. T. (2003). Stabilization and structural design of marginal materials for use in low-volume roads. Transportation research record, 1819(1), 166-172. [5]. Meepon, I., Voottipruex, P., & Teerawattanasuk, C. (2019). Marginal lateritic soil treated using ceramic waste for rural road application. Geomate Journal, 16(53), 70-77. [6]. Havanagi, V. G., Sinha, A. K., Parvathi, G. S., & Chandra, S. (2017). Municipal solid waste in road embankment construction—a case study. J. Indian Roads Congr, 78-90. [7]. Havanagi, V., Sinha, A. K., & Parvathi, G. S. (2018). Characterization of Phosphogypsum waste for Road construction. In Proceedings of the Indian Geotechnical Conference (Vol. 40, pp. 1-5). [8]. Sreekantan, P. G., Sinha, A. K., & Havangi, V. G. (2019). Red mud-fly ash mix as an embankment fill material. In Geotechnics for Transportation Infrastructure: Recent Developments, Upcoming Technologies and New Concepts, Volume 2 (pp. 247-258). Springer Singapore. [9]. Sinha, A. K., Havanagi, V. G., & Shahu, J. T. (2021). Stabilised jarofix waste material for road construction. International Journal of Pavement Engineering, 22(7), 882-893. [10]. Vinoth, M., Sinha, A. K., Guruvittal, U. K., & Havanagi, V. G. (2022). Strength of stabilised waste foundry sand material. Indian Geotechnical Journal, 52(3), 707-719. [11]. Taiwo, B. O., Aderoju, R. O., Falade, O. M., Fissha, Y., Ogunyemi, O. B., Omosebi, A. O., ... & Ogundiran, M. (2023). Mine Geo-environment Assessment: Carbonate Rock Mine Waste as Construction Material Addictive and Coupled with Pollution Index Model. Journal of Mining and Environment, 14(1), 179-196. [12]. Altaf, S., Singh, K., & Sharma, A. (2023). Sustainable Utilization of Waste Foundry Sand and Sodium Chloride in Soil Stabilization. Journal of Mining and Environment, 14(3), 897-908. [13]. Chandan, A., & Sharma, A. (2023). Sub-grade Characteristics of Flexible Pavements Incorporating Shredded Face Mask in Clayey Soil. Journal of Mining and Environment, 14(3), 789-797. [14]. Kehagia, F. (2010). A successful pilot project demonstrating the re-use potential of bauxite residue in embankment construction. Resources, Conservation and Recycling, 54(7), 417-421. [15]. Mahmood, A. A., & Mulligan, C. N. (2010, January). Investigation of the use of mine tailings for unpaved road base. In Proceedings of the annual international conference on soils, sediments, water and energy (Vol. 12, No. 1, p. 11). [16]. Fang, Y., Gu, Y., Kang, Q., Wen, Q., & Dai, P. (2011). Utilization of copper tailing for autoclaved sand–lime brick. Construction and Building Materials, 25(2), 867-872. [17]. Collins, R. J., & Miller, R. H. (1979). Utilization of mining and mineral processing wastes in the United States. Minerals and the Environment, 1, 8-19. [18]. Ahmed, I. & Lovell, C.W. (1992). Use of waste materials in highway construction: state of the practice and evaluation of the selected waste products. Transportation Research Record, 1345. [19]. Kanalli, S. A., Naagesh, S., & Ganesh, K. (2015). A review on utilization of mine waste on black cotton soil. International Journal of Research in Engineering and Technology, 4(7), 499-504. [20]. Lu, Z., & Cai, M. (2012). Disposal methods on solid wastes from mines in transition from open-pit to underground mining. Procedia Environmental Sciences, 16, 715-721. [21]. Gupta, A. K., & Paul, B. (2015). A review on utilisation of coal mine overburden dump waste as underground mine filling material: a sustainable approach of mining. International Journal of Mining and Mineral Engineering, 6(2), 172-186. [22]. Chindris, L., Arad, V., Arad, S., & Radeanu, C. (2017). Valorization of mining waste in the construction industry general considerations. International Multidisciplinary Scientific GeoConference: SGEM, 17, 309-315. [23]. Segui, P., Safhi, A. E. M., Amrani, M., & Benzaazoua, M. (2023). Mining wastes as road construction material: A review. Minerals, 13(1), 90. [24]. Russell, D. (1992). Finite element analysis of embankments on soft ground incorporating reinforcement and drains (Doctoral dissertation, University of Sheffield). https://core.ac.uk/download/pdf/9554331.pdf [25]. Zhuang, Y., & Li, S. (2015). Three-dimensional finite element analysis of arching in a piled embankment under traffic loading. Arabian Journal of Geosciences, 8, 7751-7762. [26]. Sreekantan, P. G., Mariya Dayana, A.K.Sinha, and Vasant G. Havanagi (2022). Three-Dimensional Finite Element Analysis of Shankumugham Beach Road Due to Rainfall-Induced Storm Surge. Proceedings of the Indian Geotechnical Conference- IGC 2022, Kochi, India. [27]. HZL Report (2019). Environmental statement. Zawar Mines, Hindustan Zinc Limited, Udaipur, Rajasthan, India. https://www.hzlindia.com/wp-content/uploads/Environment-Statement-Zawar-mines-1.pdf [28]. Wang, G. C. (2016). The utilization of slag in civil infrastructure construction. Duxford, UK, Woodhead Publishing Is an Imprint of Elsevier. [29]. Moolman, P. L., & Vietti, A. (2012). Tailings disposal: an approach to optimize water and energy efficiency. Platinum. In Proceedings of the Fifth Intl Platinum Conf.: a Catalyst for Change, the Southern African Institute of Mining and Metallurgy. Sun City, South Africa, 767-780. [30]. IMYB (2019). Lead and zinc, Indian minerals year book. 58th ed. Nagpur, India: Indian bureau of mines. Government of India [31]. IBM (2011). Market survey on lead and zinc. Market survey series No. MS-34. Mineral economics division, Indian bureau of mines, Ministry of mines, Nagpur, Government of India. [32]. Lu, Z., & Cai, M. (2012). Disposal methods on solid wastes from mines in transition from open-pit to underground mining. Procedia Environmental Sciences, 16, 715-721. [33]. IS 2720-part 4 (2015). Methods of test for soils: grain size analysis (sieve and hydrometer). New Delhi: Bureau of Indian Standards. [34]. IS 2720-part 5 (2015). Methods of test for soils: determination of liquid limit and plastic limit. New Delhi: Bureau of Indian Standards. [35]. IS 1498 (2007). Classification and identification of soils for general engineering purposes. New Delhi: Bureau of Indian Standards. [36]. IS 2720-part 40(2011). Methods of test for soils: determination of free swelling index of soils. New Delhi: Bureau of Indian Standards. [37]. IS 2720-Part 2 (2015). Methods of test for soils: determination of water content of soils. New Delhi: Bureau of Indian Standards. [38]. IS 2720-part 3 (2011). Methods of test for soils: determination of specific gravity of soils. New Delhi: Bureau of Indian Standards. [39]. IS 2720-part 16 (2011). Methods of test for soils: laboratory determination of CBR. New Delhi: Bureau of Indian Standards. [40]. IS 2720-part 17 (2011). Laboratory determination of permeability. New Delhi: Bureau of Indian Standards. [41]. IS 2720-part 10 (2015). Methods of test for soils: determination of unconfined compressive strength. New Delhi, India: Bureau of Indian standard. [42]. Tatu, F., & Stematiu, D. (2019). Safety analysis of Novat tailings dam. In E3S Web of Conferences (Vol. 85, p. 07018). EDP Sciences. [43]. Sinha, A. K., Havanagi, V. G., Sreekantan, P. G., & Chandra, S. (2022). Geotechnical characterisation of zinc tailing waste material for road construction. Geomechanics and Geoengineering, 17(6), 1984-2004. [44]. IS 1727 (2013). Method of test for pozzolanic materials. New Delhi: Bureau of Indian Standards. [45]. IS 2720-part 13 (2011). Methods of test for soils: direct shear test. New Delhi: Bureau of Indian Standards. [46]. ASTM D6637M (2015). Standard Test Method for Determining Tensile Properties of Geogrids by the Single or Multi- Rib Tensile Method. ASTM International:West Conshohocken, PA, USA. [47]. ASTM D4595 (2017). Standard Test Method for Tensile Properties of Geotextiles by the Wide-Width Strip Method. ASTM International: West Conshohocken, PA, USA. | ||
|
آمار تعداد مشاهده مقاله: 610 تعداد دریافت فایل اصل مقاله: 572 |
||