Evaluating the Impact of Mechanical Activation on the Microstructural Properties of Hematite Using Shape Parameter | ||
| Journal of Mining and Environment | ||
| مقاله 18، دوره 16، شماره 6، آذر و دی 2025، صفحه 2087-2097 اصل مقاله (1018.38 K) | ||
| نوع مقاله: Original Research Paper | ||
| شناسه دیجیتال (DOI): 10.22044/jme.2025.16522.3231 | ||
| نویسنده | ||
| Behzad Nemati akhgar* | ||
| Mining Engineering Department, Engineering Faculty, Urmia University, Urmia, Iran | ||
| چکیده | ||
| Researchers in various engineering fields are increasingly interested in evaluating the influence of the microstructural properties of minerals, such as hematite, on their reactivity. Hematite behaviour and microstructural changes during mechanical activation (MA) were investigated using the shape parameter. The laser diffraction analysis indicates the occurrence of agglomeration in the mechanically activated hematite after 60 min of MA. Based on the microstructural studies, the hematite crystallinity reduced to below 16% after 240 min of MA. Microstrain and crystallite size continuously changed during MA, leading to an increase in hematite leaching efficiency by sulfuric acid. The results revealed that the microstrain variation rate is higher than other microstructural parameters. The obtained shape parameter increased from about 0.31 in the initial hematite to 0.88 and 0.66 in the hematite mechanically activated for 60 and 240 min, respectively. The shape parameter study demonstrated that most mechanical energy is stored in the hematite lattice as microstrain after 240 minutes of MA. Considering the lower impact of microstrain on promoting hematite reactivity, shorter MA times could be preferred over prolonged MA, which would reduce costs and increase capacity. | ||
| کلیدواژهها | ||
| Hematite؛ X-ray diffraction؛ Shape parameter؛ Sulfuric acid leaching؛ Microstructure | ||
| مراجع | ||
|
[1]. Wills, B.A. (1985). Mineral processing technology, 3rd ed., Pergamon Press, Oxford, 521 P.
[2]. Clout, J.M.F., & Manuel, J.R. (2015). Mineralogical, chemical and physical characterization of iron ore. In: Lu, L. (Ed.), Iron Ore, Woodhead Publishing, Oxford, pp. 45–84.
[3]. Kiptarus, J.J., Muumbo, A.M., Makokha, A.B., & Kimutai, S.K. (2015). Characterization of selected mineral ores in the eastern zone of Kenya: case study of Mwingi North Constituency in Kitui County. International Journal of Mining Engineering and Mineral Processing, 4, 8–17.
[4]. Akhgar, B.N., Kheiri, S., Faridazad, M., Chehreghani, S., & Bahrami, A. (2024). Modification of mineral processing circuit in Arjin mine through a mineralogical study: magnetic separation and reverse flotation. Iranian Journal of Earth Science, 16, 1–9.
[5]. Saravari, A., Sam, A., & Shayanfar, S. (2021). Desulfurization of iron ore concentrate using a combination of magnetic separation and reverse flotation. Journal of Chemical Technology and Metallurgy, 56: 1102–1110.
[6]. Yu, J., Ge, Y. and Cai, X. (2016). The desulfurization of magnetite ore by flotation with a mixture of xanthate and dixanthogen. Minerals, 6, 70.
[7]. Bai, S., Li, J., Bi, Y., Yuan, J., Wen, S., & Ding, Z. (2023). Adsorption of sodium oleate at the microfine hematite/aqueous solution interface and its consequences for flotation. International Journal of Mining Science and Technology, 33, 105–113.
[8]. Song, S., Zhang, G., Luo, Z., & Lv, B. (2019). Development of a fluidized dry magnetic separator and its separation performance tests. Mineral Processing and Extractive Metallurgy Review, 40, 307–313.
[9]. Mackay, D.A.R., Simandl, G.J., Luck, P., Grcic, B., Li, C., Redfearn, M., & Gravel, J. (2015). Concentration of carbonatite indicator minerals using a Wilfley gravity shaking table: a case history from the Aley carbonatite. Geological Fieldwork 2014, British Columbia Geological Survey Paper, pp. 189.
[10]. Vinhal, J.T., Costa, R.H., Junior, A.B.B., Espinosa, D.C.R., & Tenório, J.A.S. (2020). Gravity separation of zinc mine tailing using Wilfley shaking table to concentrate hematite. In: Energy Technology 2020: Recycling, Carbon Dioxide Management, and Other Technologies, Springer International Publishing.
[11]. Prusti, P., Rath, S.S., Dash, N., Meikap, B.C., & Biswal, S.K. (2021). Pelletization of hematite and synthesized magnetite concentrate from a banded hematite quartzite ore: A comparison study. Advanced Powder Technology, 32, 3735–3745.
[12]. Haghi, S.M.A., Zabett, A., & Mirjalili, M. (2021). The mechanism of the reduction of hematite-magnetite concentrate by graphite-calcium carbonate mixture in Hoganas process. Journal of Metallurgical and. Materials Engineering, 32, 45–56.
[13]. Liang, Z., Peng, X., Huang, Z., Chen, J., Li, J., Yi, L., & Huang, B. (2023). Non-isothermal reduction kinetics of low-grade iron ore–coal mini-pellet in a low-temperature rotary kiln process. Materials Today Communications, 35, 105607.
[14]. Yu, J., Sun, H., Sun, X., Guo, Y., Zhang, W., & Li, Y. (2025). Kinetic study on low-temperature reduction of hematite in a microfluidized bed: Effect of pore characteristics on reaction rate. Materials Today Communications, 46, 112886.
[15]. Huang, H., Li, J., Li, X., & Zhan, Z. (2013). Iron removal from extremely fine quartz and its kinetics. Separation and Purification Technology, 108, 45–50.
[16]. Lee, S.O., Tran, T., Jung, B.H., Kim, S.J., & Kim, M.J. (2007). Dissolution of iron oxide using oxalic acid. Hydrometallurgy, 87, 91.
[17]. Martínez-Luévanos, A., Rodríguez-Delgado, M.G., Uribe-Salas, A., Carrillo-Pedroza, F.R., & Osuna-Alarcón, J.G. (2011). Leaching kinetics of iron from low grade kaolin by oxalic acid solutions. Applied Clay Science, 51, 473–477.
[18]. Tuncuk, A., & Akcil, A. (2016). Iron removal in production of purified quartz by hydrometallurgical process. International Journal of Mineral Processing, 153, 44–50.
[19]. Feng, D., & van Deventer, J.S.J. (2007). Effect of hematite on thiosulphate leaching of gold. International Journal of Mineral Processing, 82, 138–147.
[20]. Salmimies, R., Mannila, M., Kallas, J., & Häkkinen, A. (2012). Acidic dissolution of hematite: Kinetic and thermodynamic investigations with oxalic acid. International Journal of Mineral Processing, 110–111, 121–125.
[21]. Carmignano, O.R., Vieira, S.S., Teixeira, A.P.C., Lameiras, F.S., Brandão, P.R.G., & Lago, R.M. (2021). Iron ore tailings: Characterization and applications. Journal of the Brazilian Chemical Society, 32, 1895–1911.
[22]. Nyarige, J.S., Krüger, T.P.J., & Diale, M. (2020). Influence of precursor concentration and deposition temperature on the photoactivity of hematite electrodes for water splitting. Materials Today Communications, 25, 101459.
[23]. Pourghahramani, P., & Forssberg, E. (2006). Microstructure characterization of mechanically activated hematite using XRD line broadening. International Journal of Mineral Processing, 79, 106–119.
[24]. Ermolovich, E.A., & Ermolovich, O.V. (2016). Effects of mechanical activation on the structural changes and microstructural characteristics of the components of ferruginous quartzite beneficiation tailings. International Journal of Mining Science and Technology, 26, 1043–1049.
[25]. Akhgar, B.N., & Pourghahramani, P. (2015). Impact of mechanical activation and mechanochemical activation on natural pyrite dissolution. Hydrometallurgy, 153, 83–87.
[26]. Pourghahramani, P., & Akhgar, B.N. (2006). Characterization of structural changes of mechanically activated natural pyrite using XRD line profile analysis. International Journal of Mineral Processing, 134, 23–28.
[27]. Pourghahramani, P., & Akhgar, B.N. (2015). Influence of mechanical activation on the reactivity of natural pyrite in lead (II) removal from aqueous solutions. Journal of Industrial and Engineering Chemistry, 25, 131–137.
[28]. Balaz, P. (2003). Mechanical activation in hydrometallurgy. International Journal of Mineral Processing, 72, 341–354.
[29]. Akhgar, B.N., Pazouki, M., Ranjbar, M., Hosseinnia, A., & Salarian, R. (2012). Application of Taguchi method for optimization of synthetic rutile nanopowder preparation from ilmenite concentrate. Chemical Engineering Research and Design, 90, 220–228.
[30]. Akhgar, B.N., Kavanlouei, M., Farhoudi, S., & Rohzad, M.H. (2024). Impact of mechanical activation and mechanochemical activation on microstructural changes, leaching rate and leachability of natural chalcopyrite. Mineral Engineering, 217, 108962.
[31]. Clearfield, A., Riebenspies, J.H., & Bhuvanesh, N. (2009). Principle and Application of Powder Diffraction, 1st ed., Wiley-Blackwell, Hoboken, 426 P.
[32]. Chen, L.Q., & Gu, Y. (2014). Computational Metallurgy. In: Laughlin, D.E. and Hono, K. (Eds.), Physical Metallurgy, 5th ed., Elsevier, Oxford, pp. 2807–2835.
[33]. Norrish, K. (1962). Quantitative analysis by X-ray diffraction. Clay Minerals, 5(28), 98–109.
[34]. Tahmasebi, R., Shamanian, M., Abbasi, M.H., & Panjepour, M. (2009). Effect of iron on mechanical activation and structural evolution of hematite-graphite mixture. Journal of Alloys and Compounds, 472, 334–342.
[35]. Cullity, B.D., & Stock, S.R. (2009). Elements of X-ray Diffraction, 3rd ed., Prentice Hall, New Jersey, 664 P.
[36]. Li, C., Liang, B., & Wang, H. (2008). Preparation of synthetic rutile by hydrochloric acid leaching of mechanically activated Panzhihua ilmenite. Hydrometallurgy, 91, 121–129.
[37]. Zdujić, M., Jovalekić, C., Karanović, Lj., Mitrić, M., Poleti, D., & Skala, D. (1998). Mechanochemical treatment of α-Fe₂O₃ powder in air atmosphere. Materials Science and Engineering: A, 245, 109–117. | ||
|
آمار تعداد مشاهده مقاله: 31 تعداد دریافت فایل اصل مقاله: 48 |
||