[1] Zhang SH, Dankert J (1998) Development of hydro mechanical deep drawing. J Mater Process Tech 83: 14-25.

[2] Lang LH, Wang ZR, Kang DC, Yuan SJ, Zhang SH, Danckert J, Nielsen KB (2004) Hydroforming highlights: sheet hydroforming and tube   hydroforming. J Mater Process Tech 151: 165-177.

[3] Khandeparkar T, Liewald M (2008) Hydromechanical deep drawing of cups with stepped geometries. J Mater Process Tech 202: 246-254.

[4] Zhang SH, Wang ZR, Xu Y, Wang ZT, Zhou LX (2004) Recent developments in sheet hydroforming technology. J Mater Process Tech 151: 237-241.

[5] Lang L, Danckert J (2004) Investigation into hydrodynamic deep drawing assisted by radial pressure Part I. Experimental observations of the forming process  of  aluminum alloy. J Mater Process Tech 148: 119-131.

[6] Kawka M, Olejnik L, Rosochowski A, Sunaga H, Makinouchi A (2001) Simulation of wrinkling in sheet metal forming. J Mater Process Tech 109: 283-289.

[7] Thiruvarudchelvan S, Tan MJ (2004) The drawing of conical cups using an annular urethane pad. J Mater Process Tech 147: 163-166.

[8] Lang L, Gu G, Li T, Zhou X (2008) Numerical and experimental confirmation of the calibration stage’s effect in multi-operation sheet hydroforming using poor-formability materials. J Mater Process Tech 201: 97-100.

[9] Gorji A, Alavi-Hashemi H, Bakhshi-jooybari M, Nourouzi S, Hosseinipour SJ (2011) Investigation of hydrodynamic deep drawing for conical–cylindrical cups. Int J Adv Manuf Technol 56: 915-927.

[10] Chu E, Xu Y (2004) Hydroforming of aluminum extrusion tubes for automotive applications. Part II: process window diagram. Int J Mech Sci 46: 285-297.

[11] Vollertsen F, Hu Z (2010) Analysis of punch velocity dependent process window in micro deep drawing. PROD ENGINEER 4: 553-559.

[12] Gao T, Liu Y, Wang Z (2014) Research on process window diagrams of tube-compression by viscous pressure forming. J Mater Eng Perform 23: 2020-2024.

[13] Lang L, Danckert J, Nielsen KB (2005) Investigation into hydrodynamic deep drawing assisted by radial pressure Part II. Numerical analysis of the drawing mechanism and the process parameters. J Mater Process Tech 166: 150-161.

[14]  ABAQUS 6.12. Documentation, User’s manual.

[15] Liu X, Xu Y, Yuan Sh (2008) Effects of loading paths on hydrodynamic deep drawing with independent radial hydraulic pressure of aluminum alloy based on numerical simulation. Int  Mater Sci Technol 24: 395-399.

[16] Lang L, Danckert J, Nielsen KB (2005) Investigation into hydrodynamic deep drawing assisted by radial pressure Part II. Numerical analysis of the drawing mechanism and the process parameters. J Mater Process Tech 166: 150-161.

[17] Choi H, Koc M, Ni J (2007) Determination of optimal loading profiles in warm hydroforming of lightweight materials. J Mater Process Tech 190: 230-242.

[18] Papadia G, DelPrete A, Spagnolo A, Anglani A (2010) Pre-Bulging influence on an inverse drawn shape obtained with Hydromechanical Deep Drawing (HDD). Int J Mater Form 3: 287-290.